Milpro™ Dynamic with new Milpro™ 18 milk claw

Economic milk claws: performances at low cost

Milpro™ silicon liners

Short liners







Moving forwards in mastitis prevention:
milking to the maximum levels!

Features:

Excellent adherence also with the lower level of vacuum
Delicate for the udder, pleasantly soft and not irritating for the teats
Hygiene thanks to the perfectly smooth and resistant inside surface of Milpro™ silicon liners
Healthy, because the natural defence ability of the cow's udder is unchanged
Fixed position of the teat cup without moves or go up again during the milking
Maximum lasted, constant elasticity and strength of tension
Available versions with Milpro™ 450 FC clusters for side and rear milking:
1. without valve for automatic teat cup remover
2. Max Flow, with ø 15 increased nipples for cows with high flow milk




Milpro™ Milkline silicon liners
The optimal use of the silicon liners is successful thanks to the patented combination of teat cup, liner and protection ring that guarantees high resistance and long duration against kicks and falls.


Milk flow dynamic separation of each quarter thanks to a special patented deflector
The deflector form, together with its separating walls of single quarters, prevents to the milk incoming from the liners to go into the bowl with the typical turbulence and removes moreover every risks of “spray” effect between the single teat.
Big discharge speed due to the central cluster outlet.


No more vacuum fluctuations
The patented deflector positioned internally in the upper claw piece, just in front of the liners nipples. It prevents that the milk flow, incoming from each quarter, falls immediately into the bowl, forcing it to flow along the claw walls and eliminating consequently the typical vacuum fluctuations of all big dimension claws.



New XF milk bowl: increased milk flow outlet
The new XF milk bowl with increased milk flow outlet has been produced for Milkline Milpro™ 450 professional clusters range. The new XF milk bowl allows a very high milk flow, a better vacuum stability and a minimal vertical encumbrance of the milking unit thanks to the reduced nipple's angle shot.



Milk bowl with new angle shot
Reduced outlet angle
Visual check of the milk flow for quarters
ø 18 increased milk flow pipe
Site Map|Contact Us|Newsletter Subscription|Privacy|Disclaimer
Milkline Srl - Via Mattei, 4 - 29027 Loc. Gariga di Podenzano (PC) - Italy - Tel. +39-0523.524245 r.a. - Fax +39-0523.524242
Codice Fiscale e numero d’iscrizione: 01058090331 del Registro delle imprese di Piacenza | Data di iscrizione: 19/02/1996
Iscritta nella sezione ORDINARIA | Iscritta con il numero di repertorio Economico Amministrativo 124388 il 17/06/1991
Capitale sociale versato: euro 220.000,00